Raymarine Rudder Dokumentacja Pobierz pdf (Strona 28)

18 ST60+ Rudder Angle Indicator Instrument Owner’s Handbook

Connecting to the tiller

When connecting the Rotary Rudder Reference Transducer to the tiller, ensure this

is done in accordance with the limits shown in the

Rotary Rudder Reference

Transducer - as fitted

illustration (below), and that the tiller and arm of the Rotary

Rudder Reference Transducer are parallel to each other.

1. With the rudder amidships, ensure that the Rotary Rudder Reference Trans-

ducer arm is opposite the point of cable entry and at 90° to the connecting

bar. If any minor adjustment is necessary, loosen the three securing screws,

rotate the Rotary Rudder Reference Transducer body to achieve the required

adjustment, then re-tighten the screws.

2. Position the tiller pin within the limits shown. Ideally, dimension ‘A’ should be

5.5 in (140 mm). Secure the tiller ball-pin to the tiller arm using the two self-

tapping screws provided.

CAUTION: Orient the transducer arm correctly

As the Rotary Rudder Reference Transducer arm movement is

limited to ±60°, ensure that you install the transducer so the arm

is opposite the point of cable entry when the rudder is

amidships. Failure to do this could result in damage if the arm is

driven onto its end stops by the steering system.

Parallel

Cable

entry

Rudder amidships

± 60

maximum

travel

permitted

D4428-1

Min 101mm (4in)

'A' 140mm (5.5in)

Max 190mm (7.5in)

Min

75mm

(3in)

Max

310mm

(12.2in)

max

40 max

Rotary Rudder Reference Transducer - as fitted

81266_1.book Page 18 Monday, December 5, 2005 9:28 AM

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 43 44

Komentarze do niniejszej Instrukcji

Brak uwag

Raymarine Rudder Dokumentacja Strona 28

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Nie Raymarine Rudder