Raymarine SmartPilot SPX-30 Instrukcja Instalacji Pobierz pdf (Strona 31)

Chapter 3: Check and adjust settings 23

Rudder limit

The rudder limit screen is displayed only if a rudder reference transducer is fitted.

WARNING: If no rudder reference has been fitted you MUST ensure that

adequate provision is made to prevent the steering mechanism from

impacting the endstops.

If a rudder reference transducer is fitted, this screen is used to set the limits of the

rudder control just inside the mechanical end stops, and thus avoid putting the

steering system under unnecessary load. This should be set when commissioning

the SmartPilot X system. The limit should be set to approximately 5 degrees less than

the maximum rudder angle.

1. Use < or > to increase or decrease the setting.

2. Press

ENTER

to accept the new value.

Rudder offset

This specifies the offset from amidships (zero

adjustment).

1. Use < or > to increase or decrease the setting.

2. Press

ENTER

to accept the new value.

Reverse rudder reference

This reverses the phase of the rudder reference

display.

1. Use < or > to change the setting.

2. Press

ENTER

to accept the new value.

Press ENTER to select.

Rudder Limit

D10898-1

Sets the rudder limit.

Press ENTER to select.

Rudder Offset

D10899-1

Sets the rudder offset.

Press ENTER to select.

Reverse Rudder Reference

D10901-1

Reverses the rudder.

Port

81287_1.book Page 23 Tuesday, March 18, 2008 11:50 AM

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 47 48

Brak uwag

Raymarine SmartPilot SPX-30 Instrukcja Instalacji Strona 31